local-facilityfacility-levelFor messages sent to a syslog server, maps all messages of the severity you specify to one of the standard local log facilities defined

 

in RFC 3164. You can specify one of the following values:

 

0—maps all messages to local0.

 

1—maps all messages to local1.

 

2—maps all messages to local2.

 

3—maps all messages to local3.

 

4—maps all messages to local4.

 

5—maps all messages to local5.

 

6—maps all messages to local6.

 

7—maps all messages to local7.

 

If you do not specify a local facility, MSS sends the messages with

 

their default MSS facilities. For example, AAA messages are sent

 

with facility 4 and boot messages are sent with facility 20 by default.

enable

Enables messages to the specified target.

disable

Disables messages to the specified target.

Defaults:

 

Events at the error level and higher are logged to the switch console.

Events at the error level and higher are logged to the switch system buffer.

Trace logging is enabled, and debug-level output is stored in the switch trace buffer.

Access: Enabled.

Usage: Using the command with only enable or disable turns logging on or off for the target at all levels. For example, entering set log buffer enable with no other keywords turns on logging to the system buffer of all facilities at all levels. Entering set log buffer disable with no other keywords turns off all logging to the buffer.

Examples: To log only emergency, alert, and critical system events to the console, type the following command:

DWS-1008# set log console severity critical enable success: change accepted.

See Also:

show log config

clear log

D-Link DWS-1008 CLI Manual

507

Page 510
Image 510
D-Link dws-1008 manual Enables messages to the specified target, Disables messages to the specified target