set service-profile wep active-multicast-index

Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting multicast frames.

Syntax: set service-profile name wep active-multicast-index num

name

Service profile name.

num

WEP key number. You can enter a value from 1 through 4.

Defaults: If WEP encryption is enabled and WEP keys are defined, APs use WEP key 1 to encrypt multicast frames, by default.

Access: Enabled.

Usage: Before using this command, you must configure values for the WEP keys you plan to use. Use the set service-profile wep key-indexcommand.

Examples: The following command configures service profile sp2 to use WEP key 2 for encrypting multicast traffic:

DWS-1008# set service-profile sp2 wep active-multicast-index 2 success: change accepted.

See Also:

set service-profile wep active-unicast-index

set service-profile wep key-index

show service-profile

set service-profile wep active-unicast-index

Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting unicast frames.

Syntax: set service-profile name wep active-unicast-index num

name

Service profile name.

num

WEP key number. You can enter a value from 1 through 4.

Defaults: If WEP encryption is enabled and WEP keys are defined, APs use WEP key 1 to encrypt unicast frames, by default.

D-Link DWS-1008 CLI Manual

393

Page 396
Image 396
D-Link dws-1008 manual Set service-profile wep active-multicast-index, Set service-profile wep active-unicast-index