A stream of large packets sent to an DWS-1008 port in such a configuration can cause forwarding on the link to stop.

Examples: The following command disables autonegotiation on ports 1, 2, and 4 through 6:

DWS-1008#set port negotiation 1,2,4-6 disable

The following command enables autonegotiation on port 5:

DWS-1008#set port negotiation 5 enable

set port poe

Enables or disables Power over Ethernet (PoE) on ports connected to AP access points.

Caution! When you set the port type for AP use, you can enable PoE on the port. Use the DWS-1008’s PoE to power D-Link access points or PoE enabled devices only. If you enable PoE on ports connected to other devices, damage can result.

Syntax: set port poe port-listenable disable

port-list

enable disable

List of physical ports. MSS disables or reenables PoE on all the specified ports.

Enables PoE on the specified ports. Disables PoE on the specified ports.

Defaults: PoE is disabled on network and wired authentication ports. The state on access point ports depends on whether you enabled or disabled PoE when setting the port type. See set port type ap.

Access: Enabled.

Usage: This command does not apply to any gigabit Ethernet ports or to port 3 on the DWS-1008 switch.

Examples: The following command disables PoE on ports 3 and 5, which are connected to an access point:

D-Link DWS-1008 CLI Manual

48

Page 51
Image 51
D-Link dws-1008 manual Set port poe, DWS-1008#set port negotiation 1,2,4-6 disable, DWS-1008#set port negotiation 5 enable