D-Link dws-1008 manual Access Enabled

Access: Enabled.

Usage: Use the command without any optional parameters to create new profile. If the radio profile does not already exist, MSS creates a new radio profile. Use the enable or disable option to enable or disable all the radios using a profile. To assign the profile to one or more radios, use the set ap radio radio-profilecommand.

To change a parameter in a radio profile, you must first disable all the radios in the profile. After you complete the change, you can reenable the radios.

To enable or disable specific radios without disabling all of them, use the set ap radio command.

Examples: The following command configures a new radio profile named rp1:

DWS-1008# set radio-profile rp1 success: change accepted.

The following command enables the radios that use radio profile rp1:

DWS-1008# set radio-profile rp1 mode enable success: change accepted.

The following commands disable the radios that use radio profile rp1, change the beacon interval, then reenable the radios:

DWS-1008#set radio-profile rp1 mode disable

DWS-1008#set radio-profile rp1 beacon-interval 200

DWS-1008#set radio-profile rp1 mode enable

The following command enables the WPA IE on AP radios in radio profile rp2:

DWS-1008# set radio-profile rp1 mode enable success: change accepted.

See Also:

•set radio-profile mode

•set {ap dap} radio radio-profile

•show {ap dap} config

•show radio-profile

D-Link DWS-1008 CLI Manual 348