D-Link dws-1008 manual Dynamic Resolved, Local Resolved, 152

zone-name	Time zone name of up to 32 alphabetic characters. You can use a
	standard name or any name you like.
-	Minus time to indicate hours (and minutes) to be subtracted from UTC.
	Otherwise, hours and minutes are added by default.
hours	Number of hours to add or subtract from UTC.
minutes	Number of minutes to add or subtract from UTC.

Defaults: If this command is not used, then the default time zone is UTC.

Access: Enabled.

Examples: To set the time zone for Pacific Standard Time (PST), type the following command:

DWS-1008#set timezone PST -8

Timezone is set to ‘PST’, offset from UTC is -8:0 hours.

See Also:

•clear summertime

•clear timezone

•set summertime

•set timedate

•show summertime

•show timedate

•show timezone

show arp

Displays the ARP table.

Syntax: show arp [ip-addr]

ip-addr IP address.

Defaults: If you do not specify an IP address, the whole ARP table is displayed.

Access: All.

Examples: The following command displays ARP entries:

	DWS-1008# show arp
	ARP aging time: 1200 seconds
	Host	HW Address	VLAN Type		State
---------------------------------------------------------------------------------------
10.5.4.51		00:0b:0e:02:76:f5	1	DYNAMIC	RESOLVED
10.5.4.53		00:0b:0e:02:76:f7	1	LOCAL	RESOLVED
D-Link DWS-1008 CLI Manual					152