set boot partition

Specifies the boot partition in which to look for the system image file following the next system reset, software reload, or power cycle.

Syntax: set boot partition {boot0 boot1}

boot0

Boot partition 0.

boot1

Boot partition 1.

Defaults: By default, a switch uses the same boot partition for the next software reload that was used to boot the currently running image.

Access: Enabled.

Usage: To determine the boot partition that was used to load the currently running software image, use the dir command.

Examples: The following command sets the boot partition for the next software reload to partition 1:

DWS-1008# set boot partition boot1 success: Boot partition set to boot1.

show boot

Displays the system image and configuration filenames used after the last reboot and configured for use after the next reboot.

Syntax: show boot

Defaults: None.

Access: Enabled.

Examples: The following command shows the boot information for a switch:

DWS-1008# show boot

 

Configured boot version:

4.1.0.65

Configured boot image:

boot1:mx040100.020

Configured boot configuration:

file:configuration

Backup boot configuration:

file:backup.cfg

Booted version:

4.1.0.65

Booted image:

boot1:mx040100.020

Booted configuration:

file:configuration

Product model:

switch

D-Link DWS-1008 CLI Manual

302

Page 305
Image 305
D-Link dws-1008 manual Set boot partition, Show boot, Syntax set boot partition boot0 boot1 Boot0, Boot1