D-Link dws-1008 manual Set fdb agingtime, Set security l2-restrict, Mode enable disable

set fdb agingtime

Changes the aging timeout period for dynamic entries in the forwarding database.

Syntax: set fdb agingtime vlan-idage seconds

vlan-id	VLAN name or number. The timeout period change applies only to entries
	that match the specified VLAN.
age seconds	Value for the timeout period, in seconds. You can specify a value from
	0 through 1,000,000. If you change the timeout period to 0, aging is
	disabled.

Defaults: The aging timeout period is 300 seconds (5 minutes).

Access: Enabled.

Examples: The following command changes the aging timeout period to 600 seconds for entries that match VLAN orange:

DWS-1008# set fdb agingtime orange age 600 success: change accepted.

See Also:

• show fdb agingtime

set security l2-restrict

Restricts Layer 2 forwarding between clients in the same VLAN. When you restrict Layer 2 forwarding in a VLAN, MSS allows Layer 2 forwarding only between a client and a set of MAC addresses, generally the VLAN’s default routers. Clients within the VLAN are not permitted to communicate among themselves directly. To communicate with another client, the client must use one of the specified default routers.

Syntax: set security l2-restrict vlan vlan-id[mode {enable disable}] [permit-mac mac-addr[mac-addr]]

vlan-id	VLAN name or number.
mode {enable disable}	Enables or disables restriction of Layer 2 forwarding.
permit-mac mac-addr	MAC addresses to which clients are allowed to forward data at
[mac-addr]	Layer 2. You can specify up to four addresses.

D-Link DWS-1008 CLI Manual 65