show ip https

Displays information about the HTTPS management port.

Syntax: show ip https

Defaults: None.

Access: All.

Examples:The following command shows the status and port number for the HTTPS management interface to the switch:

DWS-1008>show ip https

 

HTTPS is enabled

 

HTTPS is set to use port 443

 

Last 10 Connections:

 

IP Address Last Connected

Time Ago (s)

-----------------------------------------------------------------------------

10.10.10.56 2003/05/09

15:51:26 pst 349

The table below describes the fields in this display.

Field

Description

 

 

HTTPS is

State of the HTTPS server:

• Enabled

enabled/disabled

• Disabled

 

 

 

HTTPS is set to use port

TCP port number on which the switch listens for HTTPS connections.

 

 

Last 10 connections

List of the last 10 devices to establish connections to the switch’s

HTTPS server.

 

 

 

 

IP address of the device that established the connection.

IP Address

Note: If a browser connects to a switch from behind a proxy, then only

 

the proxy IP address is shown. If multiple browsers connect using the

 

same proxy, the proxy address appears only once in the output.

 

 

Last Connected

Time when the device established the HTTPS connection to the

switch.

 

 

 

Time Ago (s)

Number of seconds since the device established the HTTPS connection

to the switch.

 

 

 

See Also:

clear ip telnet

set ip https server

set ip telnet

set ip telnet server

show ip telnet

D-Link DWS-1008 CLI Manual

159

Page 162
Image 162
D-Link dws-1008 manual Show ip https, Displays information about the Https management port, DWS-1008 show ip https