D-Link dws-1008 Load config, Syntax load config url, Backupconfigs/configc, DWS-1008#load config

load config

Caution: This command completely removes the running configuration and replaces it with the configuration contained in the file. D-Link recommends that you save a copy of the current running configuration to a backup configuration file before loading a new configuration.

Loads configuration commands from a file and replaces the switch’s running configuration with the commands in the loaded file.

Syntax: load config [url]
url	Filename. Specify between 1 and 128 alphanumeric characters,
	with no spaces.
	If the file is in a subdirectory, specify the subdirectory name,
	followed by a forward slash, in front of the filename. For example:
	backup_configs/config_c.

Defaults: The default file location is nonvolatile storage.

Note: The current version supports loading a configuration file only from the switch’s nonvolatile storage. You cannot load a configuration file directly from a TFTP server.

If you do not specify a filename, MSS uses the same configuration filename that was used for the previous configuration load. For example, if the switch used configuration for the most recent configuration load, MSS uses configuration again unless you specify a different filename. To display the filename of the configuration file MSS loaded during the last reboot, use the show boot command.

Access: Enabled.

Usage: This command completely replaces the running configuration with the configuration in the file.

Examples: The following command reloads the configuration from the most recently loaded configuration file:

DWS-1008#load config

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y success: Configuration reloaded

The following command loads configuration file testconfig1:

DWS-1008#load config testconfig1

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y success: Configuration reloaded

See Also:

•save config

•show boot

•show config

D-Link DWS-1008 CLI Manual 295