D-Link dws-1008 - page 529

D-Link DWS-1008 CLI Manual 526

The table below describes the ﬁelds in the display.

Field Description

BOOT Index Boot proﬁle slot, which can be a number from 0 to 3.

BOOT TYPE

Boot type:

• c—Compact ﬂash. Boots using nonvolatile storage or a ﬂash card.

• n—Network. Boots using a TFTP server.

DEVICE

Location of the system image ﬁle:

• c:—Nonvolatile storage area containing boot partition 0

• d:—Nonvolatile storage area containing boot partition 1

• e:—Primary partition of the ﬂash card in the ﬂash card slot

• f:—Secondary partition of the ﬂash card in the ﬂash card slot

• boot0—boot partition 0

• boot1—boot partition 1

When the boot type is Network, the device can be one of the following:

• mgmt or tsec0—The 10/100 port labelled Mgmt

HOST IP For network booting, the IP address of the host where the system image

resides

LOCAL IP For network booting, the IP address of the switch. If the DHCP option is enabled,

this does not need to be speciﬁed.

GATEWAY IP For network booting, the default router (gateway) used by the switch. If the

DHCP option is enabled, this does not need to be speciﬁed.

IP MASK For network booting, the subnet mask. If the DHCP option is enabled, this does

not need to be speciﬁed.

FILENAME System image ﬁle name.

FLAGS Number representing the bit settings of boot ﬂags to pass to the booted system

image.

OPTIONS String up to 128 bytes of boot options to pass to the booted system image.