D-Link dws-1008 manual Set system location, Set system name, Syntax set system location string

set system location

Stores location information for the DWS-1008 switch.

Syntax: set system location string

string Alphanumeric string up to 256 characters long, with no blank spaces.

Defaults: None.

Access: Enabled.

To view the system location string, type the show system command.

Examples: To store the location of the switch in the switch’s configuration, type the following command:

DWS-1008# set system location first-floor-bldg3success: change accepted.

See Also:

•clear system

•set system contact

•set system name

•show system

set system name

Changes the name of the switch from the default system name and also provides content for the CLI prompt, if you do not specify a prompt.

Syntax: set system name string

string Alphanumeric string up to 256 characters long, with no blank spaces.

Defaults: By default, the system name and command prompt have the same value. The factory default for both is DWS-mmmm-nnnnnn, where mmmm is the model number and nnnnnn is the last 6 digits of the 12-digit system MAC address.

Access: Enabled.

D-Link DWS-1008 CLI Manual 27