Table: Defaults for Radio Profile Parameters (continued)

Parameter

Default Value

Radio Behavior When Parameter Set to Default Value

 

 

Uses dynamically generated keys rather than statically configured

psk-phrase

No passphrase defined

keys to authenticate WPA clients.

 

 

 

 

 

No preshared key

Uses dynamically generated keys rather than statically configured

psk-raw

keys to authenticate WPA clients.

defined

 

 

 

 

 

 

rsn-ie

disable

Does not use the RSN IE in transmitted frames. (The RSN IE is

required for 802.11i. RSN is sometimes called WPA2.)

 

 

 

 

 

Does not use shared-key authentication.

shared-key-auth

disable

This parameter does not enable PSK authentication for WPA. To

 

 

enable PSK encryption for WPA, use the set radio-profile auth-

 

 

psk command.

short-retry-count

5

Sends a short unicast frame up to five times without

acknowledgment.

 

 

 

soda

disable

Sygate On Demand Agent (SODA) files are not downloaded to

connecting clients.

 

 

 

ssid-name

dlink

Uses the SSID name dlink.

 

 

 

 

static-cos

disable

Assigns CoS based on the Qos mode (wmm or svp) or based on

ALCs.

 

 

 

tkip-me-time

6000

Uses Michael countermeasures for 60,000ms (60 seconds)

followin detertion of a second MIC failure within 60 seconds.

 

 

 

 

 

Accepts associations only from clients that support one of the

 

 

mandantory rates.

 

802.11a:

Sends beacons at the specified rate (6Mbps for 802.11a, 2Mbps

 

• mandantory: 6.0, 12.0, 24.0

 

for 802.11b/g.

 

• beacon rate: 6.0

 

 

 

multicast-rate: auto

Sends multicast data at the highest rate that can reach all clients

 

• disabled: none

 

connected to the radio.

 

 

 

802.11b:

Accepts frames from clients at all valid data rates. (No rates are

 

• mandantory: 1.0, 2.0

 

disabled by default.)

 

• beacon rate: 2.0

transmit-rates

 

multicast-rate: auto

 

 

 

 

• disabled: none

 

 

802.11g:

 

 

• mandantory: 1.0, 2.0, 5.5,

 

 

11.0

 

 

• beacon rate: 2.0

 

 

multicast-rate: auto

 

 

• disabled: none

 

 

 

 

 

 

 

D-Link DWS-1008 CLI Manual

354

Page 357
Image 357
D-Link dws-1008 manual Link DWS-1008 CLI Manual 354