set boot backup-configuration

Specifies the name of a backup configuration file to be used in the event that MSS cannot read the switch’s configuration file at boot time.

Syntax: set boot backup-configuration filename

filenameName of the file to use as a backup configuration file if MSS cannot read the switch’s configuration file.

Defaults: By default, there is no backup configuration file.

Access: Enabled.

Examples: The following command specifies a file called backup.cfg as the backup configuration file on the switch:

DWS-1008# set boot backup-configuration backup.cfg success: backup boot config filename set.

See Also:

clear boot backup-configuration

show boot

set boot configuration-file

Changes the configuration file to load after rebooting.

Syntax: set boot configuration-file filename

filename

Filename. Specify between 1 and 128 alphanumeric characters, with

 

no spaces.

 

To load the file from a subdirectory, specify the subdirectory name,

 

followed by a forward slash, in front of the filename. For example:

 

backup_configs/config_c.

Defaults: The default configuration filename is configuration.

Access: Enabled.

Usage: The file must be located in the switch’s nonvolatile storage.

Examples: The following command sets the boot configuration file to testconfig1:

DWS-1008# set boot configuration-file testconfig1 success: boot config set.

D-Link DWS-1008 CLI Manual

301

Page 304
Image 304
D-Link dws-1008 Set boot backup-configuration, Set boot configuration-file, Syntax set boot backup-configuration filename