Low bias.
The default bias is high. Enabled
Number of a Distributed AP for which to change the bias. Configures bias for the AP configuration profile.
High bias.
List of ports on which to change the bias for directly connected APs.

Defaults: The default radio type for the DWL-8220AP is 802.11g.

Access: Enabled

Examples: The following command sets the radio type to 802.11b:

DWS-1008# set dap auto radiotype 11b success: change accepted.

See Also:

set dap auto

set dap auto mode

set dap auto persistent

set {ap dap} bias

Changes the bias for an AP. Bias is the priority of one DWS-1008 switch over other DWS-1008 switches for booting and configuring the AP.

Syntax: set {ap port-list dap {dap-num auto}} bias {high low} ap port-list

dap dap-num dap auto high

low

Defaults:

Access:

Usage: High bias is preferred over low bias. Bias applies only to DWS-1008 switches that are indirectly attached to the AP through an intermediate Layer 2 or Layer 3 network. An AP always attempts to boot on AP port 1 first, and if a DWS-1008 is directly attached on AP port 1, the AP always boots from it.

D-Link DWS-1008 CLI Manual

315

Page 318
Image 318
D-Link dws-1008 manual Set ap dap bias, Set dap auto Set dap auto mode Set dap auto persistent, Dap dap-num dap auto high