Snoop Commands

Use snoop commands to monitor wireless traffic, by using a Distributed AP as a sniffing device. The AP copies the sniffed 802.11 packets and sends the copies to an observer, which is typically a protocol analyzer such as Ethereal or Tethereal.

This chapter presents snoop commands alphabetically. Use the following table to locate commands in this chapter based on their use.

Remote monitoring (snooping)

clear snoop on page 496

 

clear snoop map on page 497

 

set snoop on page 497

 

set snoop map on page 500

 

set snoop mode on page 501

 

show snoop on page 502

 

show snoop info on page 502

 

show snoop map on page 503

 

show snoop stats on page 503

clear snoop

Deletes a snoop filter.

Syntax: clear snoop filter-name

filter-nameName of the snoop filter.

Defaults: None.

Access: Enabled.

Examples: The following command deletes snoop filter snoop1:

DWS-1008#clear snoop snoop1

See Also:

set snoop

show snoop info

D-Link DWS-1008 CLI Manual

496

Page 499
Image 499
D-Link dws-1008 manual Clear snoop, Remote monitoring snooping, Syntax clear snoop filter-name