D-Link dws-1008 manual Following Table describes the fields in this display

The following Table describes the fields in this display.

Field	Description
	DWS-1008 port number.
port	Note: This field is applicable only if the DWL-8220AP is directly connected to the
	DWS-1008 and the DWS-1008’s port is configured as an AP access port.
	Connection ID for the Distributed AP.
DAP	This field is applicable only if the AP is configured on the DWS-1008 as a Distributed
	AP.
	Serial ID of the DWL-8220AP access point.
serial-id	Note: This field is displayed only for Distributed APs.
AP Model	Access point mdel number.
	PoE state on the DWS-1008 port:
POE	• Enable
	• Disable
name	DWL-8220AP access point name.
	Hexadecimal fingerprint of the AP’s public encryption key.
fingerprint	Note: This field is displayed only for Distributed APs. If the field is blank, the key has
	not been verified yet by an administrator.
	State of the firmware upgrade option:
boot-download-enable	• YES (automatic upgrades are enabled)
	• NO (automatic upgrades are disabled)
	State of the option to force the AP to download a new image:
force-image-download	• YES (automatic upgrades are enabled)
	• NO (automatic upgrades are disabled)
	Names of the AP load-balancing groups to which the DWL-8220AP access point
load balancing group	belongs. If the value is None, the access point does not belong to any load balancing
	groups.
location	Location information for the AP.
contact	Contact information for the AP.
Radio	Radio number. The information listed below this field applies specifically to the radio.
	Radio type:
type	• 802.11a
	• 802.11b
	• 802.11g
channel	Channel number.
antennatype	External antenna model, if applicable.
tx pwr	Transmit power, in dBm.
profile	Radio profile that manages the radio. Until you assign the radio to a radio profile,
	MSS, assigns the radio to the default radio profile.
	Maximu power level the RF Auto-Tuning feature can set on the radio:
	• The value default means RF Auto-Tuning can set the power up to the maximum level
auto-tune max-power	allowed for the country of operation.
	• A specific numeric value means you or another administrator set the maximum
	value.

D-Link DWS-1008 CLI Manual 397