D-Link dws-1008 manual Set igmp qi, Syntax set igmp qi seconds vlan vlan-id qi seconds

VLAN name or number. If you do not specify a VLAN, the timer change applies to all VLANs.

Number of seconds that elapse between general queries sent by the switch when the switch is the querier for the subnet. You can specify a value from 1 through 65,535.

set igmp qi

Changes the IGMP query interval timer on one VLAN or all VLANs on a switch.

Syntax: set igmp qi seconds [vlan vlan-id] qi seconds

vlan vlan-id

Defaults: The default query interval is 125 seconds.

Access: Enabled.

Usage: The query interval is applicable only when the switch is querier for the subnet. For the switch to become the querier, the pseudo-querier feature must be enabled on the switch and the switch must have the lowest IP address among all the devices eligible to become a querier. To enable the pseudo-querier feature, use the set igmp querier command.

Examples: The following command changes the query interval on VLAN orange to 100 seconds:

DWS-1008# set igmp qi 100 vlan orange success: change accepted.

See Also:

•set igmp lmqi

•set igmp oqi

•set igmp qri

•set igmp querier

•set igmp mrouter

•set igmp rv

D-Link DWS-1008 CLI Manual 456