set dot1x key-tx

Enables or disables the transmission of encryption key information to the supplicant (client) in EAP over LAN (EAPoL) key messages, after authentication is successful.

Syntax: set dot1x key-tx {enable disable}

enable

Enables transmission of encryption key information to clients.

disable

Disables transmission of encryption key information to clients.

Defaults: Key transmission is enabled by default.

Access: Enabled.

Examples: Type the following command to enable key transmission:

DWS-1008# set dot1x key-tx enable success: dot1x key transmission enabled.

See Also:

• show dot1x

set dot1x max-req

Sets the maximum number of times the switch retransmits an EAP request to a supplicant (client) before ending the authentication session.

Syntax: set dot1x max-req number-of-retransmissions

number-of-retransmissionsSpecify a value between 0 and 10.

Defaults: The default number of EAP retransmissions is 2.

Access: Enabled.

Usage: To support SSIDs that have both 802.1X and static WEP clients, MSS sends a maximum of two ID requests, even if this parameter is set to a higher value. Setting the parameter to a higher value does affect all other types of EAP messages.

Examples: Type the following command to set the maximum number of EAP request retransmissions to three attempts:

DWS-1008# set dot1x max-req 3 success: dot1x max request set to 3.

D-Link DWS-1008 CLI Manual

247

Page 250
Image 250
D-Link dws-1008 manual Set dot1x key-tx, Set dot1x max-req, Syntax set dot1x key-tx enable disable Enable