Number of a Distributed AP on which to set the channel. Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Channel number. The valid channel numbers depend on the country of operation.
List of ports connected to the DWL-8220AP access points on which to set the channel.

Example: The following command sets the maximum power that RF Auto-Tuning can set on radio 1 on the DWL-8220AP access point on port 5 to 12 dBm.

DWS-1008# set ap 5 radio 1 auto-tunemax-power 12 success: change accepted.

See Also:

set radio-profile auto-tune power-config

set radio-profile auto-tune power-interval

set {ap dap} radio channel

Sets an DWS-8220AP radio’s channel.

Syntax: set {ap port-list dap dap-num} radio {1 2} channel channel-numberap port-list

dap dap-num radio 1 radio 2

channel-number

Defaults: The default channel depends on the radio type:

The default channel number for 802.11b/g is 6.

The default channel number for 802.11a is the lowest valid channel number for the country of operation.

Access: Enabled.

Usage: You can configure a radio’s transmit power on the same command line. Use the tx-poweroption. This command is not valid if dynamic channel tuning (RF Auto-Tuning) is enabled.

D-Link DWS-1008 CLI Manual

328

Page 331
Image 331
D-Link dws-1008 Set ap dap radio channel, Sets an DWS-8220AP radio’s channel, Dap dap-num radio 1 radio Channel-number