DSCP value. You can specify the value as a decimal number. Valid values are 0 to 63.
Internal CoS value. You can specify a number from 0 to 7.

Defaults: None.

Access: Enabled.

Usage: To reset all mappings to their default values, use the clear qos command without the optional parameters.

Examples: The following command resets all QoS mappings:

DWS-1008# clear qos success: change accepted.

The following command resets the mapping used to classify packets with DSCP value 44:

DWS-1008# clear qos dscp-to-qos-map 44 success: change accepted.

set qos cos-to-dscp-map

Changes the value to which MSS maps an internal QoS value when marking outbound packets.

Syntax: set qos cos-to-dscp-map level dscp dscp-valuelevel

dscp dscp-value

Defaults: The defaults are listed by the show qos command.

Access: Enabled.

Examples: The following command maps internal CoS value 5 to DSCP value 50:

DWS-1008#set qos cos-to-dscp-map 5 dscp 50

warning: cos 5 is marked with dscp 50 which will be classified as cos 6

If the change results in a change to CoS, MSS displays a warning message indicating the change. In this example, packets that receive CoS 5 upon ingress will be marked with a DSCP value equivalent to CoS 6 upon egress.

See Also:

set qos dscp-to-cos-map

show qos

D-Link DWS-1008 CLI Manual

74

Page 77
Image 77
D-Link dws-1008 manual Set qos cos-to-dscp-map, Syntax set qos cos-to-dscp-map level dscp dscp-valuelevel, Dscp dscp-value