Number of the Distributed AP for which you are clearing static IP information.

Examples The following command disables and resets radio 2 on the DWL-8220AP access point connected to port 3:

DWS-1008#clear ap 3 radio 2

clear dap boot-configuration

Removes the static IP address configuration for a Distributed AP.

Syntax: clear dap boot-configuration dap-numdap dap-num

Defaults: None.

Access: Enabled

Usage: When the static IP configuration is cleared for a Distributed AP, the next time the Distributed AP is rebooted, it uses the standard boot process.

Examples: The following command clears the static IP address configuration for Distributed AP 1.

DWS-1008#clear dap 1 boot-configuration

This will clear specified DAP devices. Would you like to continue? (y/n) [n]y

success: change accepted.

See Also:

set dap boot-ip

set dap boot-switch

set dap boot-vlan

show dap boot-configuration

D-Link DWS-1008 CLI Manual

308

Page 311
Image 311
D-Link dws-1008 manual Clear dap boot-configuration, DWS-1008#clear ap 3 radio, DWS-1008#clear dap 1 boot-configuration