D-Link dws-1008 Set ap dap upgrade-firmware, Dap auto enable disable Defaults Access Enabled

Automatic firmware upgrades of DWL-8220AP access points are enabled by default.

Disables automatic firmware upgrades.

Enables automatic firmware upgrades.

Configures firmware upgrades for the AP configuration profile.

List of ports connected to the DWL-8220AP access point(s) on which to allow automatic firmware upgrades.

AP can establish a management session with the DWS-1008 switch only if its fingerprint has been confirmed by you in MSS.

A change to DWL-8220AP security support does not affect management sessions that are already established. To apply the new setting to an DWL-8220AP, restart the DWL-8220AP.

Examples: The following command configures a DWS-1008 to require Distributed APs to have encryption keys:

DWS-1008# set dap security require success: change accepted.

See Also:

•set dap fingerprint

•show {ap dap} config

•show {ap dap} status

set {ap dap} upgrade-firmware

Disables or reenables automatic upgrade of a DWL-8220AP access point’s boot firmware.

Syntax: set {ap port-list dap {dap-num auto}} upgrade-firmware {enable disable} ap port-list

dap dap-num	Number of a Distributed AP on which to allow automatic firmware
	upgrades.

dap auto enable disable Defaults: Access: Enabled.

Usage: When the feature is enabled on a DWS-1008 port, a DWL-8220AP access point connected to that port upgrades its boot firmware to the latest version stored on the switch while booting.

Examples The following command disables automatic firmware upgrades on the DWL-8220AP access point connected to port 2:

DWS-1008#set ap 2 upgrade-firmware disable

D-Link DWS-1008 CLI Manual 333