set dot1x reauth-period

Sets the number of seconds that must elapse before the switch attempts reauthentication.

Syntax: set dot1x reauth-period seconds

seconds

Specify a value between 60 (1 minute) and 1,641,600 (19 days).

Defaults: The default is 3600 seconds (1 hour).

Access: Enabled.

Usage: You also can use the RADIUS session-timeout attribute to set the reauthentication timeout for a specific client. In this case, MSS uses the timeout that has the lower value. If the session-timeout is set to fewer seconds than the global reauthentication timeout, MSS uses the session-timeout for the client. However, if the global reauthentication timeout is shorter than the session-timeout, MSS uses the global timeout instead.

Examples: Type the following command to set the number of seconds to 100 before reauthentication is attempted:

DWS-1008# set dot1x reauth-period 100 success: dot1x auth-server timeout set to 100.

See Also:

clear dot1x reauth-period

show dot1x

set dot1x timeout auth-server

Sets the number of seconds that must elapse before the switch times out a request to a RADIUS authentication server.

Syntax: set dot1x timeout auth-server seconds

seconds

Specify a value between 1 and 65,535.

Defaults: The default is 30 seconds.

Access: Enabled.

Examples: Type the following command to set the authentication server timeout to 60 seconds:

DWS-1008# set dot1x timeout auth-server 60 success: dot1x auth-server timeout set to 60.

D-Link DWS-1008 CLI Manual

250

Page 253
Image 253
D-Link dws-1008 manual Set dot1x reauth-period, Set dot1x timeout auth-server, Syntax set dot1x reauth-period seconds