Lexmark C790 manual 124, Alarms, Timeouts

Menu item

Alarms

Alarm Control

Cartridge Alarm

Staple Alarm

Hole Punch Alarm

Timeouts

Standby Mode

Disabled 1–240

Timeouts

Sleep Mode Disabled 1–240

Timeouts

Screen Timeout 15–300

Timeouts

Print Timeout

Disabled 1–255

Description

Sets an alarm to sound when the printer requires user intervention

Available options for each alarm type are:

Off

Single

Continuous

Notes:

•Single is the factory default setting for Alarm Control and Cartridge Alarm. Single sounds three quick beeps.

•Off is the factory default setting for Staple Alarm and Hole Punch Alarm. Off means no alarm will sound.

•Continuous repeats three beeps every 10 seconds.

Specifies the number of minutes of inactivity before the system enters a lower power state

Note: 15 minutes is the factory default setting.

Specifies the number of minutes of inactivity before some systems begin entering a minimum power state

Notes:

•30 minutes is the factory default setting.

•A lower setting conserves more energy, but may require longer warm-up times.

•Select the lowest setting if the printer shares an electrical circuit with room lighting.

•Select a high setting if the printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm-up time.

•Sleep mode does not interact with Standby mode.

Sets the amount of time (in seconds) the printer waits before returning to a ready state

Note: 30 seconds is the factory default setting.

Sets the amount of time (in seconds) the printer waits to receive an end-of-job message before canceling the remainder of the print job

Notes:

•90 seconds is the factory default setting.

•When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting.

•Print Timeout is available only when using PCL emulation. This setting has no effect on PostScript emulation print jobs.

Understanding printer menus

124