D-Link dws-1008 manual Set port-group, Set reset port, Name group-name Port-list, Mode on off

The following command reenables the port:

DWS-1008# set port enable 4 success: set “enable” on port 4

See Also:

• set reset port

set port-group

Administratively disables or reenables a port.

Syntax: set port-group name group-nameport-listmode {on off}

name group-name

port-list

mode {on off}

Alphanumeric string of up to 255 characters, with no spaces.

List of physical ports. All the ports you specify are configured together as a single logical link.

State of the group. Use on to enable the group or off to disable the group. The group is enabled by default.

Defaults: Once configured, a group is enabled by default.

Access: Enabled.

Usage: Do not use dashes or hyphens in a port group name. If you do, MSS will not display or save the port group.

You can configure up to 8 ports in a port group, in any combination of ports. The port numbers do not need to be contiguous and you can use 10/100 Ethernet ports in the same port group.

After you add a port to a port group, you cannot configure port parameters on the individual port. Instead, change port parameters on the entire group. Specify the group name instead of an individual port name or number in port configuration commands.

To add or remove ports in a group that is already configured, change the mode to off, add or remove the ports, then change the mode to on.

Examples: The following command configures a port group named server1 containing ports 1 through 5, and enables the link:

DWS-1008# port-group name server1 1-5 mode on success: change accepted.

D-Link DWS-1008 CLI Manual 44