D-Link dws-1008 Defaults None Access Enabled, DWS-1008#set interface taupe ip 10.10.20.20/24

set system ip-address

Configures the system IP address. The system IP address determines the interface or source IP address MSS uses for system tasks, including the following:

•Topology reporting for dual-homed access points

•Default source IP address used in unsolicited communications such as AAA accounting reports and SNMP traps

Syntax: set system ip-address ip-addr

ip-addr	IP address, in dotted decimal notation. The address must be configured on
	one of the switch’s VLANs.
Defaults: None.
Access: Enabled.

Usage: You must use an address that is configured on one of the switch’s VLANs.

To display the system IP address, use the show system command.

Examples: The following commands configure an IP interface on VLAN taupe and configure the interface to be the system IP address:

DWS-1008#set interface taupe ip 10.10.20.20/24

success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe

DWS-1008# set system ip-address 10.10.20.20 success: change accepted.

See Also:

•clear system ip-address

•set interface

•show system

D-Link DWS-1008 CLI Manual 116