Usage: When this command is configured, all Ethernet frames emitted from the Distributed AP are formatted with an 802.1Q tag with a specified VLAN number. Frames sent to the Distributed AP that are not tagged with this value are ignored.

Examples: The following command configures Distributed AP 1 to use VLAN tag 100:

DWS-1008# set dap 1 boot-vlanvlan-tag 100 mode enable success: change accepted.

See Also:

clear dap boot-configuration

set dap boot-ip

set dap boot-switch

show dap boot-configuration

set {ap dap} contact

Specifies contact information for an AP.

Syntax: set {ap port-list dap {dap-num} contact string

ap port-list

List of ports on which to specify contact information for directly

 

connected APs.

dap dap-num

Number of a Distributed AP for which to specify contact information.

contact string

Contact information for the AP. If the contact information includes

 

spaces, enclose the string in quotes.

Defaults: None.

Access: Enabled

Usage: Use this command to specify an individual or department to contact for information or maintenance on the AP.

Examples: The following command specifies the contact person for AP 7 as Bob the IT guy.

DWS-1008# set ap 7 contact ‘Bob the IT guy’ success: change accepted.

D-Link DWS-1008 CLI Manual

320

Page 323
Image 323
D-Link dws-1008 manual Set ap dap contact, Specifies contact information for an AP, Contact string