D-Link dws-1008 manual Set igmp mrsol mrsi, Set igmp oqi

VLAN name or number. If you do not specify a VLAN, the timer change applies to all VLANs.

Number of seconds that the switch waits for a general query to arrive before electing itself the querier. You can specify a value from 1 through 65,535.

set igmp mrsol mrsi

Changes the interval between multicast router solicitations by a switch on one VLAN or all VLANs.

Syntax: set igmp mrsol mrsi seconds [vlan vlan-id]

seconds	Number of seconds between multicast router solicitations. You can specify a
	value from 1 through 65,535.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, MSS changes the
	multicast router solicitation interval for all VLANs.

Defaults: The interval between multicast router solicitations is 30 seconds by default.

Access: Enabled.

Examples: The following example changes the multicast router solicitation interval to 60 seconds:

DWS-1008# set igmp mrsol mrsi 60 success: change accepted.

See Also:

• set igmp mrsol

set igmp oqi

Changes the IGMP other-querier-present interval timer on one VLAN or all VLANs on a switch.

Syntax: set igmp oqi seconds [vlan vlan-id] oqi seconds

vlan vlan-id

Defaults: The default other-querier-present interval is 255 seconds (4.25 minutes).

Access: Enabled.

Usage: A switch cannot become the querier unless the pseudo-querier feature is enabled on the switch. When the feature is enabled, the switch becomes the querier for a subnet so long as the switch does not receive a query message from a router with a lower IP address than the IP address of the switch in that subnet. To enable the pseudo-querier feature, use set igmp querier.

D-Link DWS-1008 CLI Manual 454