Usage: This command applies only when static CoS is enabled. If static CoS is disabled, prioritization is based on the QoS mode configured in the radio profile, and on any ACLs that set CoS. To enable static CoS, use the set service-profilestatic-coscommand.

Examples: The following command changes the static CoS level to 7 (voice priority):

DWS-1008# set service-profile sp1 cos 7 success: change accepted.

See Also:

set service-profile static-cos

show service-profile

set service-profile dhcp-restrict

Enables or disables DHCP Restrict on a service profile. DHCP Restrict filters a newly associated client’s traffic to allow DHCP traffic only, until the client has been authenticated and authorized. All other traffic is captured by the DWS-1008 and is not forwarded. After the client is successfully authorized, the traffic restriction is removed.

Syntax: set service-profile name dhcp-restrict {enable disable}

name

Service profile name.

enable

Enables DHCP Restrict.

disable

Disables DHCP Restrict.

Defaults: DHCP Restrict is disabled by default.

Access: Enabled.

Usage: To further reduce the overhead of DHCP traffic, use the set service-profile no-broadcast command to disable DHCP broadcast traffic from AP radios to clients on the service profile’s SSID.

Examples: The following command enables DHCP Restrict on service profile sp1:

DWS-1008# set service-profile sp1 dhcp-restrict enable success: change accepted.

D-Link DWS-1008 CLI Manual

368

Page 371
Image 371
D-Link dws-1008 manual Set service-profile dhcp-restrict, Set service-profile static-cos Show service-profile