D-Link dws-1008 Set radio-profile rts-threshold, Defaults The default is disable Access Enabled

Syntax: set radio-profile name rfid-mode {enable disable}

name	Radio profile name.
enable	Enables radios to function as asset location receivers.
disable	Disables radios from functioning as asset location receivers.

Defaults: The default is disable.

Access: Enabled.

Examples: The following command enables radios managed by radio profile rp1 to act as asset location receivers:

DWS-1008# set radio-profilerfid-mode enable success: change accepted.

See Also:

•set radio-profile mode

•show radio-profile

set radio-profile rts-threshold

Changes the RTS threshold for the AP radios in a radio profile. The RTS threshold specifies the maximum length a frame can be before the radio uses the RTS/CTS method to send the frame. The RTS/CTS method clears the air of other traffic to avoid corruption of the frame due to a collision with another frame.

Syntax: set radio-profile name rts-threshold threshold

name Radio profile name.

threshold Maximum frame length, in bytes. You can enter a value from 256 through 3000.

Defaults: The default RTS threshold is 2346 bytes.

Access: Enabled.

Usage: You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

D-Link DWS-1008 CLI Manual 351