D-Link dws-1008 manual Set service-profile attr, Link DWS-1008 CLI Manual 357

The AP radio still buffers packets for all traffic priorities even if the client does not request U-APSD for them. However, to retrieve buffered packets for priorities that are not using U-APSD, a client must send a separate PSpoll for each buffered packet.

Syntax: set radio-profile name wmm-powersave {enable disable}

name Radio profile name.

enable Enables U-APSD.

disable Disables U-APSD.

Defaults: U-APSD is disabled by default.

Access: Enabled.

Usage: U-APSD is supported only for QoS mode WMM. If WMM is not enabled on the radio profile, use the set radio-profile qos-mode command to enable it.

Examples: The following command enables U-APSD on radio profile rp1:

DWS-1008# set radio-profile rp1 wmm-powersave enable success: change accepted.

See Also:

•set radio-profile mode

•set radio-profile qos-mode

•show radio-profile

set service-profile attr

Configures authorization attributes that are applied by default to users accessing the SSID managed by the service profile. These SSID default attributes are applied in addition to any supplied by the RADIUS server or from the local database.

Syntax: set service-profile name attr attribute-name value

name	Service profile name.
attribute-name value	Name and value of an attribute you are using to authorize SSID
	users for a particular service or session characteristic.

D-Link DWS-1008 CLI Manual 357