set fdb

Adds a permanent or static entry to the forwarding database.

Syntax: set fdb {perm static} mac-addrport port-listvlan vlan-id[tag tag-value]

perm

Adds a permanent entry. A permanent entry does not age out and remains in the

 

database even after a reboot, reset, or power cycle.

static

Adds a static entry. A static entry does not age out, but is removed from the

 

database after a reboot, reset, or power cycle.

mac-addr

Destination MAC address of the entry. Use colons to separate the octets (for

 

example, 00:11:22:aa:bb:cc).

port port-list

List of physical destination ports for which to add the entry. A separate entry is

 

added for each port you specify.

vlan vlan-id

Name or number of a VLAN of which the port is a member. The entry is added

 

only for the specified VLAN.

tag tag-value

VLAN tag value that identifies a virtual port. You can specify a number from 1

 

through 4093. If you do not specify a tag value, an entry is created for an untagged

 

interface only. If you specify a tag value, an entry is created only for the specified

 

tagged interface.

Defaults: None.

Access: Enabled.

Usage: You cannot add a multicast or broadcast address as a permanent or static FDB entry.

Examples: The following command adds a permanent entry for MAC address 00:11:22:aa:bb:cc on ports 3 and 5 in VLAN blue:

DWS-1008# set fdb perm 00:11:22:aa:bb:cc port 3,5 vlan blue success: change accepted.

The following command adds a static entry for MAC address 00:2b:3c:4d:5e:6f on port 1 in the default VLAN:

DWS-1008# set fdb static 00:2b:3c:4d:5e:6f port 1 vlan default success: change accepted.

See Also

clear fdb

show fdb

D-Link DWS-1008 CLI Manual

64

Page 67
Image 67
D-Link dws-1008 manual Set fdb, Mac-addr, Port port-list