The VLAN tag value. You can specify a number from 1 – 4095.
Enables or disables use of the specified VLAN tag on the Distributed AP.
Number of the Distributed AP for which you are specifying VLAN information.

When a static IP address is specified for a Distributed AP, there is no preconfigured DNS information or DNS name for the DWS-1008 the Distributed AP attempts to use as its boot device. If you configure a static IP address for a Distributed AP, but do not specify a boot device, then the DWS-1008 switch must be reachable via subnet broadcast.

Examples: The following command configures Distributed AP 1 to use the DWS switch with address 172.16.0.21 as its boot device.

DWS-1008# set dap 1 boot-switchswitch-ip 172.16.0.21 mode enable success: change accepted.

The following command configures Distributed AP 1 to use the DWS switch with the name dws2 as its boot device. The DNS server at 172.16.0.1 is used to resolve the name of the DWS switch.

DWS-1008# set dap 1 boot-switch name dws2 dns 172.16.0.1 mode enable success: change accepted.

See Also:

clear dap boot-configuration

set dap boot-ip

set dap boot-vlan

show dap boot-configuration

set dap boot-switch

Specifies 802.1Q VLAN tagging information for a Distributed AP.

Syntax: set dap dap-numboot-vlan vlan-tag tag-value[mode {enable disable}]

Syntax: set dap dap-num boot-vlan mode {enable disable} dap dap-num

vlan-tag tag-valuemode {enable disable}

Defaults: None.

Access: Enabled

D-Link DWS-1008 CLI Manual

319

Page 322
Image 322
D-Link dws-1008 manual Link DWS-1008 CLI Manual 319