D-Link dws-1008 manual Show port status, Displays configuration and status information for ports

show port status

Displays configuration and status information for ports.

Syntax: show port status [port-list]

port-listList of physical ports. If you do not specify a port list, information is displayed for all ports.

Defaults: None.

Access: All.

Examples: The following command displays information for all ports on a DWS-1008:

DWS-1008#show port status
Port Name	Admin	Oper Config	Actual	Type	Media

===============================================================

1	1	up	up	auto	100/full	network	10/100BaseTx
2	2	up	down	auto		network	10/100BaseTx
3	3	up	down	auto		network	10/100BaseTx
4	4	up	down	auto		network	10/100BaseTx
5	5	up	down	auto		network	10/100BaseTx
6	6	up	down	auto		network	10/100BaseTx
7	7	up	down	auto		network	no connector
8	8	up	down	auto		network	no connector

The table below describes the fields in this display.

Field	Description
Port	Port number.
Name	Port name. If the port does not have a name, the port number is listed.
	Administrative status of the port:
Admin	• up—The port is enabled.
	• down—The port is disabled.
	Operational status of the port:
Oper	• up—The port is operational.
	• down—The port is not operational.
	Port speed configured on the port:
Config	• 10—10 Mbps.
	• 100—100 Mbps.
	• auto—The port sets its own speed.
Actual	Speed and operating mode in effect on the port.
	Port type:
Type	• ap—AP access point port
	• network—Network port
	• wa—Wired authentication port
Media	Link type:
	• 10/100BaseTX—10/100BASE-T.

D-Link DWS-1008 CLI Manual 58