D-Link dws-1008 manual Set dap fingerprint, Syntax set dap dap-numfingerprint hex

set dap fingerprint

Verifies an AP’s fingerprint on an DWS-1008. If AP-DWS security is required by an DWS-1008, an AP can establish a management session with the switch only if you have verified the AP’s identity by verifying its fingerprint on the switch.

Syntax: set dap dap-numfingerprint hex

dap dap-num	Number of the Distributed AP whose fingerprint you are verifying.
hex	The 16-digit hexadecimal number of the fingerprint. Use a colon
	between each digit. Make sure the fingerprint you enter matches the
	fingerprint used by the AP.
Defaults: None.
Access: Enabled

Usage: APs are configured with an encryption key pair at the factory. The fingerprint for the public key is displayed on a label on the back of the AP, in the following format:

RSA aaaa:aaaa:aaaa:aaaa:aaaa:aaaa:aaaa:aaaa

If an AP is already installed and operating, you can use the show dap status command to display the fingerprint. The show dap config command lists an AP’s fingerprint only if the fingerprint has been verified in MSS. If the fingerprint has not been verified, the fingerprint information in the command output is blank.

Examples: The following example verifies the fingerprint for Distributed AP 8:

DWS-1008#set dap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3 success: change accepted.

See Also:

•set dap security

•show {ap dap} config

•show {ap dap} status

D-Link DWS-1008 CLI Manual 321