HA=ip-addrHost address (IP address) of a TFTP server. This parameter applies only when the boot type is n (network).

FL=num Number representing the bit settings of boot flags to pass to the booted system image. Use this parameter only if advised to do so by D-Link.

OPT=option String up to 128 bytes of boot options to pass to the booted system image instead of the boot option(s) in the currently active boot profile. The options temporarily replace the options in the boot profile. Use this parameter only if advised to do so by D-Link.

OPT+=option String up to 128 bytes of boot options to pass to the booted system image in addition to the boot option(s) in the currently active boot profile. The options are appended to the options already in the boot profile. Use this parameter only if advised to do so by D-Link.

Defaults: The boot settings in the currently active boot profile are used by default.

Access: Boot prompt.

Usage: If you use an optional parameter, the parameter setting overrides the setting of the same parameter in the currently active boot profile. However, the boot profile itself is not changed. To display the currently active boot profile, use the show command. To change the currently active boot profile, use the change command.

Examples: The following command loads system image file MX010101.020 from boot

partition 1:

boot> boot FN=MX010101.020 DEV=boot1

Compact Flash load from boot1:testcfg matches MX010101.020. unzip: Inflating ramdisk_1.1.1.. OK

unzip file len 36085486 OK

Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003

The NetBSD Foundation, Inc. All rights reserved.

Copyright (c) 1982, 1986, 1989, 1991, 1993

The Regents of the University of California. All rights reserved. Power Cycle Reboot

Detecting hardware...done.

readclock: 2003-10-8 2:9:50.67 UTC=>1065578990.670000 (1064992894)

init: Creating mfs /dev

erase ^H, werase ^W, kill ^U, intr ^C, status ^T Doing D-Link mounts and links

Starting nos_mon...

nos_mon:ps: not found

SYSLOGD Oct 08 02:10:05.477814 CRITICAL SYSTEM_READY: The system has finished booting.

Copyright (c) 2002, 2003 D-Link System, Inc. Username:

Password:

D-Link DWS-1008 CLI Manual

515

Page 518
Image 518
D-Link dws-1008 manual Boot boot FN=MX010101.020 DEV=boot1