set ip telnet

Changes the TCP port number on which a DWS-1008 switch listens for Telnet management traffic.

Caution: If you change the Telnet port number from a Telnet session, MSS immediately ends the session. To open a new management session, you must Telnet to the switch with the new Telnet port number.

Syntax: set ip telnet port-num

port-numTCP port number.

Defaults: The default Telnet port number is 23.

Access: Enabled.

Examples: The following command changes the Telnet port number on a DWS-1008 switch to 5000:

DWS-1008# set ip telnet 5000 success: change accepted.

See Also:

clear ip telnet

set ip https server

set ip telnet server

show ip https

show ip telnet

set ip telnet server

Enables the Telnet server on a DWS-1008 switch.

Caution: If you disable the Telnet server, Telnet access to the switch is also disabled.

Syntax set ip telnet server {enable disable}

enable Enables the Telnet server.

disable Disables the Telnet server. Defaults: The Telnet server is disabled by default. Access: Enabled.

D-Link DWS-1008 CLI Manual

132

Page 135
Image 135
D-Link dws-1008 manual Set ip telnet