D-Link dws-1008 manual Set dap boot-ip, Enables or disables the static IP address for the AP

Examples: The following command enables LED blink mode on the access points connected to ports 3 and 4:

DWS-1008# set ap 3-4 blink enable success: change accepted.

set dap boot-ip

Specifies static IP address information for a Distributed AP.

Syntax: set dap dap-numboot-ip ip ip-addrnetmask mask-addrgateway gateway-addr[mode {enable disable}]

Syntax: set dap dap-numboot-ip mode {enable disable}

dap dap-num	Number of the Distributed AP for which you are specifying static IP
	information.
ip ip-addr	The IP address to be assigned to the AP, in dotted decimal notation
	(for example, 10.10.10.10).
netmask mask-addr	The subnet mask, in dotted decimal notation (for example,
	255.255.255.0).
gateway gateway-addr	The IP address of the next-hop router, in dotted decimal notation.
mode {enable disable}	Enables or disables the static IP address for the AP.

Defaults: By default APs use DHCP to obtain an IP address, rather than a using a manually assigned IP address.

Access: Enabled

Usage: Normally, Distributed APs use DHCP to obtain IP address information.In some installations, DHCP may not be available. In this case, you can assign static IP address information to the AP, including the AP’s IP address and netmask, and default gateway.

If the manually assigned IP information is incorrect, the AP uses DHCP to obtain its IP address.

D-Link DWS-1008 CLI Manual 317