D-Link dws-1008 manual Set interface, Set arp Show arp, Configures an IP interface on a Vlan

Access: Enabled.

Usage: Aging applies only to dynamic entries.

To reset the ARP aging timeout to its default value, use the set arp agingtime 1200 command.

Examples: The following command changes the ARP aging timeout to 1800 seconds:

DWS-1008# set arp agingtime 1800 success: set arp aging time to 1800 seconds

The following command disables ARP aging:

DWS-1008# set arp agingtime 0 success: set arp aging time to 0 seconds

See Also:

•set arp

•show arp

Set interface

Configures an IP interface on a VLAN.

Syntax: set interface vlan-id ip {ip-addr mask ip-addr/mask-length}

vlan-id VLAN name or number.

ip-addr mask IP address and subnet mask in dotted decimal notation (for example, 10.10.10.10 255.255.255.0).

ip-addr/mask-lengthIP address and subnet mask length in CIDR format (for example, 10.10.10.10/24).

Defaults: None.

Access: Enabled.

Usage: You can assign one IP interface to each VLAN.

If an interface is already configured on the VLAN you specify, this command replaces the interface. If you replace an interface that is in use as the system IP address, replacing the interface can interfere with system tasks that use the system IP address, including the following:

•Topology reporting for dual-homed access points

•Default source IP address used in unsolicited communications such as AAA accounting reports and SNMP traps

D-Link DWS-1008 CLI Manual 88