Examples: The following command enables the SNMP server on a DWS-1008 switch:

DWS-1008# set ip snmp server enable success: change accepted.

See Also:

clear snmp trap receiver

set port trap

set snmp community

set snmp trap

set snmp trap receiver

show snmp configuration

set ip ssh

Changes the TCP port number on which a DWS-1008 switch listens for Secure Shell (SSH) management traffic.

Caution: If you change the SSH port number from an SSH session, MSS immediately ends the session. To open a new management session, you must configure the SSH client to use the new TCP port number.

Syntax: set ip ssh port port-num

port-numTCP port number.

Defaults: The default SSH port number is 22.

Access: Enabled.

Examples: The following command changes the SSH port number on a DWS-1008 switch to 6000:

DWS-1008# set ip ssh port 6000 success: change accepted.

See Also:

• set ip ssh server

D-Link DWS-1008 CLI Manual

97

Page 100
Image 100
D-Link dws-1008 manual Syntax set ip ssh port port-num, Set ip ssh server Link DWS-1008 CLI Manual