D-Link dws-1008 manual Set igmp qri, Syntax set igmp qri tenth-secondsvlan vlan-id

set igmp qri

Changes the IGMP query response interval timer on one VLAN or all VLANs on a switch.

Syntax: set igmp qri tenth-seconds[vlan vlan-id]

qri tenth-secondsAmount of time (in tenths of a second) that the switch waits for a receiver to respond to a group-specific query message before removing the receiver from the receiver list for the group. You can specify a value from 1 through 65,535.

vlan vlan-id	VLAN name or number. If you do not specify a VLAN, the timer change applies
	to all VLANs.

Defaults: The default query response interval is 100 tenths of a second (10 seconds).

Access: Enabled.

Usage: The query response interval is applicable only when the switch is querier for the subnet. For the switch to become the querier, the pseudo-querier feature must be enabled on the switch and the switch must have the lowest IP address among all the devices eligible to become a querier. To enable the pseudo-querier feature, use set igmp querier.

Examples: The following command changes the query response interval on VLAN orange to 50 tenths of a second (5 seconds):

DWS-1008# set igmp qri 50 vlan orange success: change accepted.

See Also:

•set igmp lmqi

•set igmp oqi

•set igmp qi

•set igmp querier

•set igmp rv

D-Link DWS-1008 CLI Manual 457