D-Link dws-1008 manual Set interface status, Set ip dns domain Set ip dns server Show dhcp-server

•DNS servers—If these options are not set with the set interface dhcp-server command’s primary-dns and secondary-dns options, the MSS DHCP server uses the values set by the set ip dns server command.

•Default router—If this option is not set with the set interface dhcp-server command’s default-router option, the MSS DHCP server can use the value set by the set ip route command. A default route configured by set ip route can be used if the route is in the DHCP client’s subnet. Otherwise, the MSS DHCP server does not specify a router address.

Examples: The following command enables the DHCP server on VLAN red-vlanto serve addresses from the 192.168.1.5 to 192.168.1.25 range:

DWS-1008#set interface red-vlan ip dhcp-server enable start 192.168.1.5 stop 192.168.1.25

success: change accepted.

See Also:

•set ip dns domain

•set ip dns server

•show dhcp-server

set interface status

Administratively disables or reenables an IP interface.

Syntax: set interface vlan-idstatus {up down}

vlan-idVLAN name or number.

up Enables the interface.

down Disables the interface.

Defaults: IP interfaces are enabled by default.

Access: Enabled.

Examples: The following command disables the IP interface on VLAN mauve:

DWS-1008# set interface mauve status down success: set interface mauve to down

See Also:

•clear interface

•set interface

•show interface

D-Link DWS-1008 CLI Manual 91