Defaults: None

Access: Enabled.

Usage: To simplify configuration and avoid confusion between a port’s number and its name, D-Link recommends that you do not use numbers as port names.

Examples: The following command sets the name of port 4 to adminpool:

DWS-1008# set port 4 name adminpool success: change accepted.

See Also:

• clear port name

set port negotiation

Disables or reenables autonegotiation on gigabit Ethernet or 10/100 Ethernet ports.

Syntax: set port negotiation port-list{enable disable}

port-list

enable disable

List of physical ports. MSS disables or reenablesautonegotiation on all the specified ports.

Enables autonegotiation on the specified ports.

Disables autonegotiation on the specified ports.

Defaults: Autonegotiation is enabled on all Ethernet ports by default.

Access: Enabled.

Usage: The gigabit Ethernet ports operate at 1000 Mbps only. They do not change speed to match 10-Mbps or 100-Mbps links.

The DWS-1008 Ethernet ports support half-duplex and full-duplex operation.

D-Link recommends that you do not configure the mode of a DWS-1008 port so that one side of the link is set to autonegotiation while the other side is set to full-duplex. Although MSS allows this configuration, it can result in slow throughput on the link. The slow throughput occurs because the side that is configured for autonegotiation falls back to half-duplex.

D-Link DWS-1008 CLI Manual

47

Page 50
Image 50
D-Link dws-1008 Set port negotiation, Clear port name, Syntax set port negotiation port-listenable disable, Enable disable