D-Link dws-1008 Set service-profile idle-client-probing, Set service-profile keep-initial-vlan

set service-profile idle-client-probing

Disables or reenables periodic keepalives from AP radios to clients on a service profile’s SSID. When idle-client probing is enabled, the AP radio sends a unicast null-data frame to each client every 10 seconds. Normally, a client that is still active sends an Ack in reply to the keepalive.

If a client does not send any data or respond to any keepalives before the user idle timeout expires, MSS changes the client’s session to the Disassociated state.

Syntax: set service-profile name idle-client-probing {enable disable}

name	Service profile name.
enable	Enables keepalives.
disable	Disables keepalives.

Defaults: Idle-client probing is enabled by default.

Access: Enabled.

Usage: The length of time a client can remain idle (unresponsive to idle-client probes) is specified by the user-idle-timeoutcommand.

Examples: The following command disables idle-client keepalives on service profile sp1:

DWS-1008# set service-profile sp1 idle-client-probing disable success: change accepted.

See Also:

•set service-profile user-idle-timeout

•show service-profile

set service-profile keep-initial-vlan

Configures DWL-8220APs managed by the radio profile to leave a roamed user on the VLAN assigned by the switch where the user logged on. When this option is disabled, a user’s VLAN is reassigned by each DWS-1008 to which a user roams.

Syntax: set service-profile name keep-initial-vlan {enable disable}

D-Link DWS-1008 CLI Manual 369