D-Link dws-1008 manual Reset ap dap, DWS-1008#set radio-profile rp6 mode disable

Examples: The following commands disable the radios that are using radio profile rp6, remove service-profile svcprof6 from rp6, then clear svcprof6 from the configuration.

DWS-1008#set radio-profile rp6 mode disable

DWS-1008# clear radio-profile rp6 service-profile svcprof6 success: change accepted.

DWS-1008# clear service-profile svcprof6 success: change accepted.

See Also:

•clear radio-profile

•set radio-profile mode

•show service-profile

reset {ap dap}

Restarts an access point.

Syntax: reset {ap port-list dap dap-num}

ap port-list List of ports connected to the access points to restart.

dap dap-numNumber of a Distributed AP to reset.

Defaults: None.

Access: Enabled

Usage: When you enter this command, the AP drops all sessions and reboots.

Examples: The following command resets the AP on port 4:

DWS-1008# reset ap 4

This will reset specified AP devices. Would you like to continue? (y/n)y success: rebooting ap attached to port 4

D-Link DWS-1008 CLI Manual 311