D-Link dws-1008 Show vlan config, DWS-1008# show security l2-restrict, Displays Vlan information

Examples: The following command shows Layer 2 forwarding restriction information for all VLANs:

DWS-1008#show security l2-restrict
VLAN Name	En Drops	Permit MAC	Hits

-------------------------------------------------------------------------------------------------

1	default	Y	0	00:0b:0e:02:53:3e	5947
				00:30:b6:3e:5c:a8	9
2	vlan-2	Y	0	04:04:04:04:04:04	0

The table describes the fields in the display.

Field	Discription
VLAN	VLAN number.
Name	VLAN name.
	Enabled state of the feature for the VLAN:
En	•Y—Enabled.Forwarding of Layer 2 traffic from clients is restricted to the MAC address(es)
	listed under Permit MAC.
	• N—Disabled. Layer 2 forwarding is not restricted.
Drops	Number of packets dropped because the destination MAC address was not one of the
	addresses listed under Permit MAC.
Permit MAC	MAC addresses to which clients in the VLAN are allowed to send traffic at Layer 2.
Hits	Number of packets whose source MAC address was a client in this VLAN, and whose
	destination MAC address was one of those listed under Permit MAC.

See Also:

•clear security l2-restrict

•clear security l2-restrict counters

•set security l2-restrict

show vlan config

Displays VLAN information.

Syntax: show vlan config [vlan-id]

vlan-id	VLAN name or number. If you do not specify a VLAN, information for all VLANs is
	displayed.

Defaults: None.

Access: All.

D-Link DWS-1008 CLI Manual 71