show dap connection

Displays the system IP address of the DWS-1008 that booted a Distributed AP.

Syntax: show dap connection [dap-num serial-id serial-ID]

dap-num

Number of a Distributed AP for which to display information about its active

serial-idconnection.

DWL-8220AP access point serial ID.

Defaults: None.

Access: Enabled.

Usage: The serial-idparameter displays the active connection for the specified Distributed AP even if that AP is not configured on this DWS-1008. If you instead use the command with the dap-numparameter or without a parameter, connection information is displayed only for Distributed APs that are configured on this DWS-1008.

This command provides information only if the Distributed AP is configured on the switch where you use the command. The switch does not need to be the one that booted the AP, but it must have the AP in its configuration.

If a Distributed AP is configured on this DWS-1008 but does not have an active connection, the command does not display information for the AP. To show connection information for Distributed APs, use the show dap global command on one of the switches where the APs are configured.

Examples: The following command displays information for all Distributed APs configured on this DWS-1008 that have active connections:

DWS-1008#show dap connection

Total number of entries: 2

DAP

Serial Id

DAP IP Address

DWS-1008 IP Address

2

112233

10.10.2.27

10.3.8.111

4

0333000298

10.10.3.34

10.3.8.111

D-Link DWS-1008 CLI Manual

417

Page 420
Image 420
D-Link dws-1008 Show dap connection, Syntax show dap connection dap-num serial-id serial-ID, DWS-1008#show dap connection