Defaults: STP backbone fast path convergence is disabled by default.

Access: Enabled.

Usage: If you plan to use the backbone fast convergence feature, you must enable it on all the bridges in the spanning tree.

Examples: The following command enables backbone fast convergence:

DWS-1008# set spantree backbonefast enable success: change accepted.

See Also:

• show spantree backbonefast

set spantree fwddelay

Changes the period of time after a topology change that a switch which is not the root bridge waits to begin forwarding Layer 2 traffic on one or all of its configured VLANs. (The root bridge always forwards traffic.)

Syntax: set spantree fwddelay delay {all vlan vlan-id}

delay

Delay value. You can specify from 4 through 30 seconds.

all

Changes the forwarding delay on all VLANs.

vlan vlan-idVLAN name or number. MSS changes the forwarding delay on only the specified VLAN.

Defaults: The default forwarding delay is 15 seconds.

Access: Enabled.

Examples: The following command changes the forwarding delay on VLAN pink to 20 seconds:

DWS-1008# set spantree fwddelay 20 vlan pink success: change accepted.

See Also:

• show spantree

D-Link DWS-1008 CLI Manual

433

Page 436
Image 436
D-Link dws-1008 manual Set spantree fwddelay, Syntax set spantree fwddelay delay all vlan vlan-id Delay