show dap unconfigured

Displays Distributed APs that are physically connected to the network but that are not configured on any DWS-1008s.

Syntax: show dap unconfigured

Defaults: None.

Access: Enabled.

Usage: This command also displays an AP that is directly connected to an DWS-1008, if the switch port to which the AP is connected is configured as a network port instead of an AP access port, and if the network port is a member of a VLAN.

Entries in the command output’s table age out after two minutes.

Examples: The following command displays information for two Distributed APs that are not configured:

DWS-1008#show dap unconfigured

Total number of entries: 2

Serial Id

Model

IP Address

Port

Vlan

0333001287

DWL-8220AP

10.3.8.54

5

default

0333001285

DWL-8220AP

10.3.8.57

7

vlan-eng

The following table describes the fields in the display:

Field

Description

Serial Id

Serial ID of the Distributed AP.

 

 

Model

AP model number.

 

 

 

IP address of the AP. This is the address that the AP receives from a DHCP

 

server. The AP uses this address to send a Find DWS message to request

IP Address

configuration information from DWL-1008.

 

 

However, the AP cannot use the address to establish a connection unless the

 

AP first receives a configuration from an DWS-1008.

 

 

Port

Port number on which this DWS-1008 received the AP’s Find DWS message.

 

 

VLAN

VLAN on which this DWS-1008 received the AP’s Find DWS message.

 

 

D-Link DWS-1008 CLI Manual

420

Page 423
Image 423
D-Link dws-1008 manual Show dap unconfigured, Syntax show dap unconfigured Defaults None Access Enabled