Nortel Networks 2300 Series manual Set service-profile transmit-rates

344AP Commands

History Introduced in WSS Software Version 3.0.

Usage Countermeasures apply only to TKIP and WEP clients. This includes WPA WEP clients and non- WPA WEP clients. CCMP clients are not affected.

The TKIP cipher suite must be enabled. The WPA IE also must be enabled.

Examples The following command changes the countermeasures wait time for service profile sp3 to

30,000 ms (30 seconds):

WSS# set service-profile sp3 tkip-mc-time 30000

success: change accepted.

See Also

•set service-profilecipher-tkip on page 313

•set service-profilewpa-ie on page 342

•show service-profile on page 380

set service-profile transmit-rates

Changes the data rates supported by AP radios for a service-profile’s SSID.

Syntax set service-profile name transmit-rates {11a 11b 11g}

mandatory rate-list[disabled rate-list][beacon-rate rate] [multicast-rate {rate auto}]

name	Service profile name.
11a 11b 11g	Radio type.
mandatory rate-list	Set of data transmission rates that clients are required to support
	in order to associate with an SSID on an AP radio. A client must
	support at least one of the mandatory rates.
	These rates are advertised in the basic rate set of 802.11 beacons,
	probe responses, and reassociation response frames sent by AP
	radios.
	Data frames and management frames sent by AP radios use one
	of the specified mandatory rates.
	The valid rates depend on the radio type:
	•	11a—6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
	• 11b—1.0, 2.0, 5.5, 11.0
	•	11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0,
		36.0, 48.0, 54.0
	Use a comma to separate multiple rates; for example:
	6.0,9.0,12.0
disabled rate-list	Data transmission rates that AP radios will not use to transmit
	data. This setting applies only to data sent by the AP radios. The
	radios will still accept frames from clients at disabled data rates.

The valid rates depend on the radio type and are the same as the valid rates for mandatory.

NN47250-100 (Version 02.51)